Installing JRun Previous Up One Level Next
Connecting JRun to External Web Servers


Connecting a Zeus web server

This section describes how to configure JRun to communicate with a Zeus web server running on UNIX. For more information about advanced web server connection techniques, see JRun Administrator's Guide.

Connecting JRun to Zeus

Use the following procedure for connecting JRun to a Zeus web server (UNIX only).

To connect Zeus and JRun:

  1. Run the Web Server Configuration tool and connect to a JRun server.

    For details, see "Running the Web Server Configuration tool".

  2. In the Web Server Properties section of the Web Server Configuration tool, select Zeus, as the following figure shows:

    This figure shows the Web Server Properties window for NES.

  3. Enter the directory path or browse to the Zeus https-xxxx\ config directory and click Select.

    The name of the Zeus server is https-xxxx. For example, the web server config directory might be /usr/local/zeus/ns-config/https-xxxx/config.

  4. To enable the following connector settings, click Advanced:
  5. Click OK.
  6. Click Install.

    JRun connects to the web server.

  7. Ensure that your web server is running.
  8. To verify the JRun connection to your Zeus web server, open a web browser on the Zeus web server to the following URL: http://web-server-hostname.

    Note:   This step assumes that Zeus is listening for connections on the default port 80. If not, use http://web-server-hostname:webserver-port-number.

    The default page for the web server to which you connected appears, showing that you successfully configured the connection between JRun and your external web server.

Removing the JRun connection to Zeus

You can remove the web server configuration in one of two ways:

Previous Up Next